Table of Contents
Advertisement
®
eXtendo
Emulation Command Set Reference
2.1.32
ESC [F0]+[0B]+[01]+[n]
[Name]
Start block rotation
[Function]
This command signifies that all commands sent after it are to be treated as a single
block and rotated intact as specified below.
16
[Code]
[1B]
10
[27]
[Description]
1.
The "ESC [F0]+[0B]+[01]+[n]" command signifies that all commands and data sent after it, until
receipt of the End Block Rotation command, are to be treated as a single block and rotated intact
as specified below.
2.
Parameter [n] defines the angle of rotation for the entire block:
Parameter
[n]
[FF]
[00]
[01]
[02]
[03]
3.
The upper left corner of the block is the key when rotating, and the block will start as far to the
upper left as defined by the rotation of the objects sent.
The "T" in "The" is the
upper left hand corner
before rotation.
4.
Please note that all commands, including Line Feed, are stored and are used only to position and
format the data to be printed. Once this command has been sent, there will be no printing until
receipt of the End Block Rotation command, which will cause the entire block to be printed.
5.
The commands "Print uncompressed graphics" and "Print RLE8 compressed graphics" are
ignored by the Start Block Rotation command.
Part No. D 684 112
16
16
+ [F0]
+ [0B]
+
10
10
+ [240]
+ [11]
+
16
16
16
16
16
The "T" in "The" is the upper left hand corner after rotation.
Mod.Nr. 4 150813 LEV
Start block rotation
16
[01]
+
[n]
10
[01]
+
[n]
Angle of rotation
Disabled
0°
90°
180°
270°
Page 43 of 95
- Quick Links:
- 2.1 Emulation Command Set
Hide quick links:
Advertisement
Table of Contents
