Gs '+[M]+[N] Print Stored Image Data - Hengstler eXtendo X-56 Reference Manual

®
eXtendo Emulation Command Set Reference
2.1.36 GS '+[m]+[n]
[Name] Print stored image data
[Function] This command causes stored image data to be printed.
16
[Code] [1D]
10
[29]
[Description]
1. The "GS '+[m]+[n]" command causes image data, stored in flash memory, to be printed.
2. Parameter [m] specifies the identification number of the stored image. (The first stored image is
identification no. 0, the second ID no. 1, etc.)
3. The range of parameter [m], the identification number, is [0]
4. If there is no registered image stored for a transmitted identification number, then the command is
ignored.
5. Parameter [n] specifies the print mode, as follows:
Parameter [n] Print mode
10
[00] Normal
10
[01] Double width
10
[02] Double height
10
[03] Double width and
height
6. Use of values for Parameters [m] and [n] other than as described above will cause the command
to be ignored.
7. Images can be created and stored in the eXtendo
®
eXtendo print driver.
Part No. D 684 112
16
+ [27] + [m] + [n]
10
+ [39] + [m] + [n]
Caption
The stored image data is printed in the original stored size.
The stored image data is printed in double width.
The stored image data is printed in double height.
The stored image data is printed in double width and
height.
Mod.Nr. 4 150813 LEV
Print stored image data
10 10
≤ [m] ≤ [255]
®
printer by using the tools that come with the
.
Page 47 of 95