Esc [F1]+[01]+[08]+[00]+[D1] - Hengstler eXtendo X-56 Reference Manual

®
eXtendo Emulation Command Set Reference
2.1.54 ESC [F1]+[01]+[08]+[00]+[d1]...[d7] RS-232 Communication
[Name] RS-232 communication parameter setting
[Function] This command is used to specify the RS-232 communication parameters such as
baud rate, stop bits, data bits, parity and flow control.
16
[Code] [1B]
10
[27]
[Description]
1. The "ESC [F1]+[01]+[08]+[00]+[d1]...[d7]" command specifies the serial communication
parameters for RS-232 versions of the eXtendo
2. The following serial communication parameters are specified in [d1]...[d7] as follows: baud rate in
[d1], parity on/off in [d2], parity odd/even in [d3], number of data bits in [d4], number of stop bits in
[d5], flow control in [d6] and an additional block host TX (CTS signal low) on paper out flag [d7].
3. Parameter [d1] specifies the baud rates as follows:
10
[00] = 4800
10
[01] = 9600
10
[02] = 19200
10
[03] = 38400
10
[04] = 57600
10
[05] = 115200
10
[06] = 230400 (unsupported at this time)
10
[07] = 460800 (unsupported at this time)
Choosing an unsupported or undefined value will cause the printer to select 115200 baud.
4. Parameter [d2] specifies the parity on/off as follows:
10
[00] = PARITY OFF
10
[01] = PARITY ON
An unsupported or undefined value will select PARITY OFF.
5. Parameter [d3] specifies the parity even/odd as follows:
10
[00] = PARITY ODD
10
[01] = PARITY EVEN
An unsupported or undefined value will select PARITY ODD.
Parity even/odd is ignored unless parity is ON.
6. Parameter [d4] specifies the data bits as follows:
10
[00] = 7 DATA BITS (unsupported at this time)
10
[01] = 8 DATA BITS
Any value for d4 will select 8 DATA BITS.
7. Parameter [d5] specifies the stop bits as follows:
10
[00] = 1 STOP BIT
10
[01] = 2 STOP BITS
An unsupported or undefined value will select 1 STOP BIT.
8. Parameter [d6] specifies the control flow as follows:
10
[00] = NO FLOW CONTROL (unsupported)
10
[01] = HARDWARE FLOW CONTROL – RTS / CTS
10
[02] = SOFTWARE FLOW CONTROL - XON/XOFF (unsupported at this time)
An unsupported or undefined value will select HARDWARE FLOW CONTROL – RTS / CTS.
(RTS = Ready To Send, CTS = Clear To Send)
Part No. D 684 112
16 16
+ [F1] + [01] +
10 10
+ [241] + [01] +
®
Mod.Nr. 4 150813 LEV
Parameter Setting
16 16
[08] + [00] + [d1]... [d7]
10 10
[08] + [00] + [d1]... [d7]
printer.
Page 73 of 95