Esc [F1]+[01]+[02]+[07]+[N] Customer Flag Setting - Hengstler eXtendo X-56 Reference Manual

®
eXtendo Emulation Command Set Reference
2.1.57 ESC [F1]+[01]+[02]+[07]+[n]
[Name] Customer flag setting command
[Function] This command sets or resets the customer flags
16
[Code] [1B]
10
[27]
[Description]
1. The "ESC [F1]+[01]+[02]+[07]+[n]" command is used to specify the state of the two customer
flags.
2. The customer flag settings are stored in flash memory, whereas each defined flag can either be 1
or 0.
3. The customer flags are intended to be used to distinguish multiple printers that are connected to
a single host. The printer transmits the flags in the Status Packets (see command "GS a + [n]",
Request Printer Status)
4. Customer flags are to be specified in an 8-bit unsigned byte, whereas the least significant bit is
status flag #1 and the next bit is status flag #2.
5. Following customer flags are defined:
Bit Description
Customer status flag #1 for the
®
0 eXtendo
a+[n]")
Customer status flag #2 for the
®
1 eXtendo
a+[n]")
2-15 Reserved
Part No. D 684 112
16 16
+ [F1] + [01] + [02]
10 10
+ [241] + [01] + [02]
status message (see "GS
status message (see "GS
Mod.Nr. 4 150813 LEV
Customer Flag Setting
16 16
+ [07] + [n]
10 10
+ [07] + [n]
Contents
0: Disabled 1: Enabled
0: Disabled 1: Enabled
0 (this value should always be set to "0")
Page 77 of 95