Cylinder Head Removal; Remove Intake Pipe - Toyota 1KZ-TE Repair Manual

CLICK HERE TO VIEW CHAPTER INDEX
EM- -44
(b)
(c)
(a)
(b)
ENGINE MECHANICAL
(d)
S04839
P11700
(c)
S04841
- - CYLINDER HEAD
RE M O VAL
1 . DRAI N E NG I NE CO O L ANT
2.

REMOVE INTAKE PIPE

(a) Disconnect the VSV for the No.1 and No.2 intake
constrictor control connectors.
(b) Disconnect the vacuum hose from the actuator of the
chamber A
(c) Disconnect the vacuum hose from the actuator of the
chamber B
(d) Disconnect the vacuum hose from the 3--way (from vacu-
um pump)
(e) Remove the 4 nuts and 4 seal washers.
(f) Use pliers to pinch the ends of the clamp together until the
lock plate engages the catch.
Make sure the lock plate and catch are engaged securely.
(g) Remove the intake pipe, PCV hose and gasket.
(h) Remove the accelerator cable bracket from the intake
pipe.
(i) Remove the VSV for the No.1 and No.2 intake constrictor
control. (See page ED -- 13)
(j) Remove the bolt and vacuum hose clamp from the cylin-
der head.
3 . RE MO V E TURBO CHARG E R
4. REMOVE INJECTION PIPES
5 . RE MO V E WATE R O UTLE T
(a) Disconnect the check connector.
(b) Disconnect the engine wire clamp.
(c) Disconnect the turbo pressure sensor connector.
(d) Disconnect the water temperature sender gauge connec-
tor.
(e) Remove the 2 nuts, water outlet and gasket.
1KZ-TE Pages From Manual
TO MODEL INDEX
EM15D- -01
(S e e pa ge TC - - 6 )
(See pa ge FU - - 5)
CONTINUED