Toyota 1KZ-TE Repair Manual page 206

CLICK HERE TO VIEW CHAPTER INDEX
TC- -8
E--Ring
Snap Ring
V--Band
TURBOCHARGING
6 .
Actuator
(a)
(b)
NOTICE:
Never apply more than 141 kPa (1.44 kgf/cm
pressure to the actuator.
SST
(c)
S04398
(d)
7.
(a)
(b)
HINT:
Do not remove the snap ring with force from the turbocharger.
B09285
(c)
NOTICE:
Remove the compressor housing as straight as possible
and do not make the impeller wheel interfere with the com-
pressor housing.
B09286
8 .
(a)
(b)
Matchmarks
B09287
- - TURBOCHARGER
RE MO V E ACTUATO R
Disconnect the actuator hose form the compressor hous-
ing.
Using SST, apply pressure to the actuator.
SST 09992 -- 00242
Remove the 2 bolts holding the actuator to the compres-
sor housing.
Remove the E--ring holding the actuator push rod to the
waste gate valve link, and remove the actuator.
REMOVE COMPRESSOR HOUSING
Place the matchmarks on the compressor housing and
bearing housing.
Using snap ring pliers, remove the snap ring from the
compressor housing.
Using a plastic--faced hammer, tap out the compressor
housing.
RE MO V E BE ARI NG HO US I NG
Place the matchmarks on the V--band, turbine housing
and bearing housing.
Remove the bolt, nut and V--band.
1KZ-TE Pages From Manual
TO MODEL INDEX
2
, 20.5 psi) of
CONTINUED