Toyota 1KZ-TE Repair Manual page 210

CLICK HERE TO VIEW CHAPTER INDEX
TC- -12
Matchmark
TURBOCHARGING
Pin
Pin Hole
B09295
B09306
SST
B09307
Old V--Band
New V--Band
B08667
- - TURBOCHARGER
RE AS S E M BLY
1 . I NS TALL BE ARI NG HO US I NG
(a) Install the snap ring to the turbocharger.
HINT:
In advance, put the snap ring through the bearing housing.
(b) Install a new O--ring to the bearing housing.
(c) Align the pin of the turbine housing with the pin hole of the
bearing housing.
(d) Install the bearing housing to the turbine housing.
NOTICE:
Install the bearing housing straight, and be careful
S S S S
not to damage the turbine wheel.
In case of having difficulty of pressing in the bearing
S S S S
housing to install with a hand due to hard engage-
ment, apply the procedure (c).
HINT:
Apply a little penetrate rust prevention lubricant onto the en-
gagement section to make installation easier.
(e) In case that the engagement of the bearing housing is
hard, using SST and a press, install the bearing housing
while checking the smooth rotation of the impeller wheel.
SST 09350 -- 32014 (09351 -- 32070)
NOTICE:
Do not hold the turbine housing with the stud bolts.
S S S S
Be sure to install the bearing housing straight without
S S S S
tilting as the shaft may bent and cause the irregular
noise.
Press in the bearing housing slowly. When the rota-
S S S S
tion of the impeller wheel becomes heavy, return the
press immediately and do the operation again.
After installed, check that the turbine shaft turns
S S S S
smoothly.
(f) Place a new and old (used) V--bands in line, then reprint
the matchmark position on the old V--band to the new
one.
1KZ-TE Pages From Manual
TO MODEL INDEX
TC035- -01
CONTINUED