Toyota 1KZ-TE Repair Manual page 184

CLICK HERE TO VIEW CHAPTER INDEX
ENGINE MECHANICAL
(b) Using a micrometer, measure the diameter of the balance
shaft main journals.
Main journal diameter (from front side):
(c) Subtract the balance shaft main journal diameter mea-
surement from the balance shaft bearing inside diameter
P12238
measurement.
Standard oil clearance:
Maximum oil clearance:
If the clearance is greater than maximum, replace the cylinder
block and balance shaft.
11 . INSPECT CRANKS HAFT F O R RUNO UT
(a) Place the crankshaft on V--blocks.
(b) Using a dial indicator, measure the circle runout at the
center journal.
Maximum circle runout: 0.06 mm (0.0024 in.)
If the circle runout is greater than maximum, replace the crank-
shaft.
Center
Journal
P11733
12. INSPECT MAIN J OURNALS AND CRANK P I NS
(a) Using a micrometer, measure the diameter of each main
journal and crank pin.
Main journal diameter:
U/S 0.25
U/S 0.50
P11734
- - CYLINDER BLOCK
No.1 41.941 - - 41.960 mm (1.6512 - - 1.6520 in.)
No.2 40.931 - - 40.950 mm (1.6115 - - 1.6122 in.)
No.3 31.941 - - 31.960 mm (1.2575 - - 1.2583 in.)
No.1 0.040 - - 0.079 mm (0.0016 - - 0.0031 in.)
No.2 0.040 - - 0.079 mm (0.0016 - - 0.0031 in.)
No.3 0.050 - - 0.089 mm (0.0020 - - 0.0035 in.)
No.1
No.2
No.3
STD 69.982 - - 70.000 mm (2.7552 - - 2.7559 in.)
69.745 - - 69.755 mm (2.7459 - - 2.7463 in.)
69.495 - - 69. 505 mm (2.7360 - - 2.7364 in.)
1KZ-TE Pages From Manual
TO MODEL INDEX
EM- -89
0.18 mm (0.0071 in.)
0.19 mm (0.0075 in.)
0.18 mm (0.0071 in.)
CONTINUED