Removal Of Cylinder Head; Remove Alternator; Remove Air Intake Chamber With Connector - Toyota 7M-GE Repair Manual

ENGINE MECHANICAL
- Cylinder Head
EM-&j
REMOVAL OF CYLINDER HEAD
1.
(See pages EM-37, 38)
REMOVE AiiERNATOR
(a) Disconnect the No.3 PCV hose.
(b) Remove the drive belt.
(c) Remove the alternator and adjusting bar.
2.
3.
4.
(7M-GTE)
REMOVE PS RESERVOIR TANK
Remove the two bolts, nut and, reservoir tank with bracket.
('IM-GTE),
REMOVE CAM POSITION SENSOR
REMOVE AIR INTAKE CHAMBER WITH CONNECTOR
(a) Remove the PCV pipe.
(b) Disconnect following connectors:
. (7M-GE)
Cold start injector connector
l
Throttle position sensor connector
l
ISC valve connector
(c) Disconnect following hoses:
aI
l BVSV hose from throttle body
l
EGR hoses from throttle.boby
l
Vacuum transmitting p.ipe hose from intake cham-
ber
0 Pressure regulator hose
;, I
l
VSV (for fuel pressure up) &es
. (7 M-GE)
Diaphragm hose
(d) Disconnect following hoses:
-
0 (7M-GTE)
Auxiliary air pipe hose from vacuum transmitting
pipe hose
l
No.1 water by-pass hose from ISC valve
. (7M-GE)
No.3 water by-pass hose from throttle body ,
0 (-/M-GTE)
No.3 water by-pass hose from water by-pass pipe
(e) (w/ EGR)
Remove the EGR pipe mounting bolts.
(f) Remove the manifold stay mounting bolts.