Check Piston Stroke Of Overdrive Brake; The Procedures Are Presented In A Step--By--Step Format; Specifications - Toyota 1KZ-TE Repair Manual

CLICK HERE TO VIEW CHAPTER INDEX
IN- -2

The procedures are presented in a step--by--step format:

The illustration shows what to do and where to do it.
S
The task heading tells what to do.
S
The detailed text tells how to perform the task and gives other information such as specifications
S
and warnings.
Example:
Illustration:
what to do and where
This format provides the experienced technician with a FAST TRACK to the information needed. The upper
case task heading can be read at a glance when necessary, and the text below it provides detailed informa-
tion. Important specifications and warnings always stand out in bold type.
6 . RE FE RE NCE S
References have been kept to a minimum. However, when they are required you are given the page to refer
to.
7.

SPECIFICATIONS

Specifications are presented in bold type throughout the text where needed. You never have to leave the
procedure to look up your specifications. They are also found in Service Specifications section for quick ref-
erence.
8 . CAUTI O NS , NO TI CE S , HI NTS :
CAUTIONS are presented in bold type, and indicate there is a possibility of injury to you or other
S
people.
NOTICES are also presented in bold type, and indicate the possibility of damage to the components
S
being repaired.
HINTS are separated from the text but do not appear in bold. They provide additional information to
S
help you perform the repair efficiently.
9 . S I UNI T
The UNITS given in this manual are primarily expressed according to the SI UNIT (International System of
Unit), and alternately expressed in the metric system and in the English System.
Example:
Torque: 30 N∙m (310 kgf∙cm, 22 ft∙lbf)
INTRODUCTION - - HOW TO USE THIS MANUAL

21. CHECK PISTON STROKE OF OVERDRIVE BRAKE

(a) Place SST and a dial indicator onto the overdrive brake pis-
ton as shown in the illustration.
SST 09350- -30020 (09350- -06120)
Set part No.
Detailed text :
(b) Measure the stroke applying and releasing the compressed
air (392 — 785 kPa, 4 — 8 kgf/cm
in the illustration.
Piston stroke: 1.40 — 1.70 mm (0.0551 — 0.0669 in.)
1KZ-TE Pages From Manual
TO MODEL INDEX
Task heading : what to do
Component part No.
how to do task
2
or 57 — 114 psi) as shown
Specification