Install Rectifier Holder; Install Ic Regulator And Brush Holder; Install Rear End Cover - Toyota 1KZ-TE Repair Manual

CLICK HERE TO VIEW CHAPTER INDEX
SST (A)
Turn
Upward
SST (C)
P08701
Protrusion
B09663
Approx.
1 mm
P12622
B00762
CHARGING - - ALTERNATOR
(h) Turn SST (B) and remove SST (A and B).
4.

INSTALL RECTIFIER HOLDER

Install the rectifier holder with the bolt and 4 screws.
Torque: Screw: 1.96 N∙m (20 kgf∙cm, 17.4 in.∙lbf)
Torque: Bolt:
5.

INSTALL IC REGULATOR AND BRUSH HOLDER

(a) Install the brush holder cover to the brush holder.
NOTICE:
Be careful of the holder installation direction.
(b) Place the IC regulator together with the brush holder hori-
zontally on the rectifier end frame.
(c) Install the 5 screws until there is a clearance of approx. 1
mm (0.04 in.) between the brush holder and connector.
Torque: 1.96 N∙m (20 kgf∙cm, 17 in.∙lbf)
(d) Fit the brush holder cover.
6.

INSTALL REAR END COVER

(a) Install the end cover with the 3 nuts.
Torque: 4.5 N∙m (46 kgf∙cm, 40 in.∙lbf)
(b) Install the terminal insulator with the nut.
Torque: 4.1 N∙m (42 kgf∙cm, 36 in.∙lbf)
7. CHECK THAT ROTOR ROTATES SMOOTHLY
1KZ-TE
3.9 N∙m (40 kgf∙cm, 34.7 in.∙lbf)
Pages From Manual
TO MODEL INDEX
CH- -13