Chapter 2. Installation; Unpacking And Inspection - Comtech EF Data DMD50 Installation And Operation Manual

Chapter 2. Installation

2.1

Unpacking and Inspection

Inspect shipping containers for damage. If shipping containers are damaged, keep them until the
contents of the shipment have been carefully inspected and checked for normal operation.
The Universal Satellite Modem and its Installation and Operation Manual are packaged and shipped
in a pre-formed, reusable cardboard carton containing foam spacing for maximum shipping
protection.
Do not use any cutting tool that will extend more than 1/2 inch into the container.
This can cause damage to the modem.
CAUTION
Unpack and inspect the modem as follows:
Step Procedure
1
Cut the tape at the top of the carton indicated by
Remove the cardboard/foam space covering the modem.
2
Remove the modem, power cord, and user's manual from the carton.
3
4 Save the packing material for storage or reshipment purposes.
Inspect the equipment for any possible damage incurred during shipment.
5
Note: If damage is evident, contact the carrier and Comtech EF Data immediately and
submit a damage report.
6 Check the contents against the packing list to verify completeness of the shipment.
7 Refer to the sections that follow for further installation instructions.
The Universal Satellite Modem was carefully packaged to avoid damage and should arrive
complete with the following items for proper installation:
1. DMD50 Universal Satellite Modem
2. Power Cord, six foot with applicable AC Connector
3. Installation and Operation Manual
MN-DMD50– Revision 3
OPEN THIS END
.
2–1