Comtech EF Data DMD50 Installation And Operation Manual page 118

Universal satellite
Table of Contents

Advertisement

DMD50 Universal Satellite Modem
IP ADDR MASK
MODEM IP ADDR
SERVER IP ADDR
ROUTER IP ADDR
MN-DMD50– Revision 3
IP TEST : Stores and uses IP Mask and addresses to fixed settings as listed
below.
Bootp Server Tag:
IP Address Mask:
Modem IP Address:
Server IP Address:
Router IP Address:
BOOTp SERVER
Only used if Bootp is selected in Boot Mode. Should be
consistent with the tag expected by the users Bootp Server.
MODEM HOST
{XXX.XXX.XXX.XXX} Hexidecimal Mask
{ddd.ddd.ddd.ddd} Decimal Mask
The IP Address Mask of the local network. The mask is
expressed in a hexadecimal format, and must be a valid TCP/IP
Mask. This field should be set before changes are made to the
Modem or Router Address.
{XXX.XXX.XXX.XXX} Hexidecimal Address
{ddd.ddd.ddd.ddd} Decimal Mask
The IP Address of the modem. This address should be consistent
for the mask defined. This address is expressed in hexadecimal
format. Broadcast and loop back addresses will not be allowed.
These are addresses with all subnet bits set to 0's or 1's.
{XXX.XXX.XXX.XXX} Hexidecimal Address
{ddd.ddd.ddd.ddd} Decimal Address
The IP Address of the Boot Server and the address of the SNMP
Trap Server when SNMP is active. If a server is used and there
is no local router, this address must be consistent with the
modem address. If a router has been specified, the address is
presumed to be reachable via the router. Broadcast and loop
back addresses will not be allowed. These are addresses with all
subnet bits set to 0's or 1's.
{XXX.XXX.XXX.XXX} Hexidecimal Address
{ddd.ddd.ddd.ddd} Decimal Address
The IP Address of the Local Network Router. If a router is
present on the local network, this address must be consistent
with the IP Mask and the subnet of the modem. If no router is
present, then the address should be set to a foreign address. This
address is expressed in hexadecimal format.
Broadcast and loop back addresses will not be allowed. These
are addresses with all subnet bits set to 0's or 1's.
206
255.255.255.000
192.168.0.238
192.168.000.101
192.168.000.102
{128 – 257, default is 206}
The Host Modem for the network.
User Interfaces
(FF.FF.FF.00 hex)
(C0.A8.00.EE)
(C0.A8.00.65)
(C0.A8.00.66)
4–34

Advertisement

Table of Contents
loading

Table of Contents