Packet Statistics; J.1.6 Packet Statistics - Comtech EF Data DMD50 Installation And Operation Manual

DMD50 Universal Satellite Modem

J.1.6 Packet Statistics

The following statistics are available under the Monitor Menu when the Ethernet Data Interface is
selected.
Total Packets: This Counter displays the total number of Ethernet packets received from the
satellite.
Error Packets: This counter displays the total number of Ethernet packets received from the
satellite that had errors.
Packet Error Rate: This displays the Ethernet Packet Error Rate (PER) from the satellite.
Packet Statistics Reset: Allows the user to reset the Ethernet Total Packets and Ethernet Error
Count by pressing <Enter>.
Link Status: The following status is available under the Monitor Menu/Link Status Sub-Menu
when the Ethernet Data Interface is selected:
Port 1 Status: Displays the current status of LAN Port 1.
Port 2 Status: Displays the current status of LAN Port 2.
Port 3 Status: Displays the current status of LAN Port 3.
WAN Status: Displays the current status of the WAN Port.
For each of the above-listed ports, the status may take on one of the following
values/meanings.
Down:
Unresolved:
10 Mbps Half:
10 Mbps Full:
100 Mbps Half:
100 Mbps Full:
If all four LAN Ports are down, a Tx Data Activity Minor Alarm will be generated.
If the WAN Port is down, a Tx and Rx Ethernet WAN Major Alarm will be generated.
MN-DMD50 - Revision 3
The link is down.
Unable to agree on connection speed.
Connected at 10 Base-T Half Duplex.
Connected at 10 Base-T Full Duplex.
Connected at 100 Base-T Half Duplex.
Connected at 100 Base-T Full Duplex.
Ethernet Data Interface Setup
J–4