Canceling Demonstration Mode - Comtech EF Data DMD50 Installation And Operation Manual

DMD50 Universal Satellite Modem
B.4.2 Canceling Demonstration Mode
At any time, a demonstration may be canceled and have the modem return to its normal
operation. Once the demonstration has been canceled, it cannot be restarted using the old
demonstration code. In order to restart a demonstration, it will be necessary to obtain a new
demonstration code.
To cancel a demonstration from the front panel, perform the following:
1. From the modem's Main Menu, scroll right to the SYSTEM Menu.
2. Scroll down.
3. Scroll right to the HW/FW CONFIG Menu.
4. Scroll down.
5. Scroll right to the FEATURES Menu.
6. Scroll down.
The value displayed on the top line of this menu is the 12-digit Unit ID. It is displayed on the
front panel of the modem as 3 sets of 4 digits in a dot-delineated format indicated in Parameter
Setup, Chapter 4. The second line is the data entry area and is displayed as 3 sets of 4
underscores in a dot-delineated format.
Press <ENTER> and a cursor will begin flashing in the data entry area
Using the numeric keypad, enter 0000 0000 0000
Press <ENTER>.
The modem will immediately terminate the demonstration and the feature set will revert back to
the permanent configuration.
The Mod and Demod Test LED's will stop flashing.
MN-DMD50– Revision 3
Front Panel Upgrade Procedure
B–6