Change Web User Name; Change Authentication Password - Comtech EF Data DMD50 Installation And Operation Manual

DMD50 Universal Satellite Modem
1. CONFIRMATION : When ENABLED, a change in the Web Interface will prompt a secondary
window to be displayed asking "Do you want to proceed". This will allow the user to either OK
the change or cancel the change. When this feature is DISABLED, the command will be
executed upon entering the command or parameter change. Commands pertaining to frequency
and data rates cannot be overridden. The Confirmation command is located under PASSWORD
SETUP/PREFERENCES.
2. USER 1 : This will allow the operator to change the user name, assign the Access group,
authorized password for "USER 1". Upon entering the following fields will be displayed:
a. ACCESS GROUP:
"OPER", or GUEST to USER 1.
b. AUTH PASSWORD:
c. USER RESET: Using this command will allow the factory defaults (as listed in the
table above) to be restored to USER 1. This can be used in the event that USER 1 is
locked out due to password restriction.
3. USER 2 : This has the same menu structure as USER 1.
4. USER 3 : This has the same menu structure as USER 1.
Radyne's Web configuration allows for the support of 3 user profiles. These are configured
through the 'PASSWORD/SETUP ACCESS section in the Web Browser.
D.3

Change Web User Name

Any of the three available user names can be modified.
1. Go to <USERx> Submenu, press <ENTER> then move the cursor to any position and
press <CLEAR> along with the 'Right Arrow' key to clear all text to the right of the
cursor.
2. Use the arrow keys and the numerical keypad to set the desired user name. Press
<ENTER> to accept the changes.
D.4

Change Authentication Password

1. Go to <USERx> Submenu, press 'Down Arrow' to access its corresponding lower level
sub-menus.
2. Go to <AUTH PASSWORD> Submenu, <ENTER> then move the cursor to any position
and press <CLEAR> along with the 'Right Arrow' key to clear all text to the right of the
cursor.
3. Use the arrow keys and the numerical keypad to set the desired password. Press
<ENTER> to accept the changes.
MN-DMD50– Revision 3
This will allow the assignment of "No Group", "ADMIN",
This will allow for the entry of the password for USER 1.
Web Browser Setup Guide
D–3