Table of Contents
Advertisement
DMD50 Universal Satellite Modem
TRACKING RATE
LOCAL CL ACTION
REMOTE CL ACTION
REMOTE AUPC (menu)
AUPC MODE
LOOPBACK
MN-DMD50– Revision 3
This allows the user to set the desired E
receiver.
RADYNE AUPC: When configured for Radyne AUPC, this
setting is compared against the remote E
the local modem to increase or decrease the local transmit
power.
EF AUPC: When configured for EF AUPC, this setting is
compared against the local received E
remote modem to increase or decrease transmit power.
NEARSIDE: When configured for NEARSIDE AUPC, this
setting is compared against the received E
modem and commands to the local modem to increase or
decrease transmit power.
{0.5 to 6.0}
Allows the user to set the rate at which the commands to increase
or decrease Transmit Power are sent. Each command will result
in a 0.5 dB increase or decrease in Transmit Power from the
remote transmitter. The tracking rate is adjustable from 0.5 dB
per minute to 6.0 dB per minute in 0.5 dB steps. (Only
available when EFAUPC is selected as the framing)
{HOLD, NOMINAL, MAXIMUM}
This allows the user to set the Remote Transmit Power Setting to
be used when the local modem receiver loses lock. The setting
can be 'HOLD' (no action taken), 'NOMINAL' (the nominal
Transmit Power Setting is used), and 'MAXIMUM' (the
maximum Transmit Power Setting is used). (Only available
when EFAUPC is selected as the framing)
{HOLD, NOMINAL, MAXIMUM}
This allows the user to set the Local Transmit Power Setting to
be used when the remote modem receiver loses lock. The setting
can be 'HOLD' (no action taken), 'NOMINAL' (the nominal
Transmit Power Setting is used), and 'MAXIMUM' (the
maximum Transmit Power Setting is used).
The 'REMOTE AUPC CONFIGURATION' Menu contains the
remote configuration parameters for the AUPC Function.
Remote AUPC menus are only available when modem is
configured for EF AUPC
{DISABLE, EFDATA}
Allows the user to enable or disable the AUPC Function of the
remote modem. The remote AUPC Function is the response of
the local modem to commands for an increase or decrease of the
Transmit Power in 0.5 dB steps and the command to change to
the setting indicated in the 'REMOTE CL ACTION' Menu of the
remote modem upon receiver loss of lock.
{DISABLE, ENABLE}
User Interfaces
/N
for the local
b
o
/N
and commands to
b
o
/N
and commands to the
b
o
/N
of the local
b
o
4–10
Advertisement
Table of Contents
Troubleshooting
