Comtech EF Data DMD50 Installation And Operation Manual page 196

DMD50 Universal Satellite Modem
INSTALLED indicates that the option is already available as part of the modems feature set.
HW & KEY REQ indicates that additional hardware is required to support the option. Contact
your Radyne sales representative for more information regarding the required hardware upgrade.
KEY CODE REQ indicates that the desired option is available as a front panel upgrade.
2. Contact Radyne with the Unit ID and Desired Upgrades. The modem's Unit ID can be
found on the front panel as follows:
a. From the modem's Main Menu, scroll right to the SYSTEM Menu.
b. Scroll down.
c. Scroll right to the HW/FW CONFIG Menu.
d. Scroll down.
e. Scroll right to the FEATURES Menu.
f. Scroll down
The value displayed on the top line of this menu is the 12-digit Unit ID. It is displayed as on the
front panel of the modem as 3 sets of 4 digits in a dot-delineated format as follows:
1 2 3 4 . 1 2 3 4 . 1 2 3 4
Your Radyne sales representative will ask you for this number along with your desired feature
set upgrades when placing your order.
3. Once your order has been processed, you will be issued a 12-digit feature set upgrade
code. This code is only good on the modem for which it was ordered. To enter this code
from the front panel, perform the following:
a. From the modem's Main Menu, scroll right to the SYSTEM Menu.
b. Scroll down.
c. Scroll right to the HW/FW CONFIG Menu.
d. Scroll down.
e. Scroll right to the FEATURES Menu.
f. Scroll down.
The value displayed on the top line of this menu is the 12-digit Unit ID. It is displayed on the
front panel of the modem as 3 sets of 4 digits in a dot-delineated format indicated in Step 2. The
second line is the data entry area and is displayed as 3 sets of 4 underscores in a dot-delineated
format.
g. Press <ENTER>. A cursor will begin flashing in the data entry area.
h. Using the numeric keypad, enter your 12-digit upgrade code.
i.
If the code entered is correct, the display will display CODE ACCEPTED, otherwise the
INVALID CODE will be displayed..
MN-DMD50– Revision 3
Press <ENTER>.
Front Panel Upgrade Procedure
B–2