Terminal Port; Modem Remote Communications (Rllp); Ethernet M&C Port - Comtech EF Data DMD50 Installation And Operation Manual

DMD50 Universal Satellite Modem

3.3.1 Terminal Port

This port supports an asynchronous control protocol as described in Section 4. It is configured to
support RS-232 signal levels. This port is intended for use in computer-based remote M&C. All
functions of the modem may be monitored and controlled from this port via a common terminal
connected to the Terminal Port. This function is front panel selectable.
The Terminal Mode Control allows the use of an external terminal or computer to monitor and
control the modem from a full screen interactive presentation operated by the modem itself. No
external software is required other than VT-100 Terminal Emulation Software (e.g. "Procomm"
for a computer when used as a terminal. The Control Port is normally used as an RS–232
Connection to the terminal device. The RS-232 operating parameters can be set using the modem
Front Panel and stored in Non-volatile memory for future use.
Refer to the Remote Protocol Manual (TM117) for the Terminal, Remote and

3.3.2 Modem Remote Communications (RLLP)

The Remote Port located on J20 allows for control and monitoring of parameters and functions
via an RS-232 Serial Interface, or RS-485 for RLLP Protocol. 'Equipment Remote Mode' setup
can be entered from the front panel or the Web Browser interface under the "System" menu. This
requires the user to first set the Remote Port Control to "Remote" then set the Multidrop Address
as needed followed by setting the Remote Interface to RS232 or RS485.
Control and status messages are conveyed between the modem and all subsidiary modems and the
host computer using packetized message blocks in accordance with a proprietary communications
specification. This communication is handled by the Radyne Link Level Protocol (RLLP), which
serves as a protocol 'wrapper' for the RM&C data. Complete information on monitor and control
software is contained in the following sections.
3.3.3 Ethernet M&C Port
This port is dedicated for Ethernet Communications supporting SNMP, FTP and Web Browser.
The port is configured for 10 Base-T communications protocols. The Ethernet M&C Interface
requires a standard RJ45 Male connector. Refer to Appendix D and F for proper setup of the
TCP-IP interface and Web Browser Setup.
MN-DMD50– Revision 3
SNMP screens and protocols.
Theory of Operation
3–6