Removing The Take-Up Roll (Sc-F7000 Series) - Epson SC-F7100 Series User Manual

SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
F
Confirm that the media is attached without
deformation.
As shown in the identified sections in the
illustration below, if the tensions of the left and
right edges of the media are different, the media
cannot be taken up correctly. If there is slack on
one side, repeat from Step 1.
Note:
As shown in the illustration below, you can confirm
differences in tension by lightly tapping on both
edges of the media.
G
Press the d button to feed the media until the
take up roll core begins to turn.
c
Important:
The Auto Take-up Reel Unit will not function
if the tensioner is raised.
Removing the Take-up Roll
(SC-F7000 Series)
This section describes how to remove media from the
take-up reel.
Basic Operations
!
Caution:
❏ Because the media is heavy, it should not be
carried by one person. When loading or
removing the media, use at least two persons.
❏ Perform the following procedure to properly
remove the take-up roll.
Injury may occur if the take-up roll falls.
A
Cut the media and roll the cut end onto the
take-up reel.
"Cutting Media" on page 44
U
B
To prevent the media from sliding off the roll,
support the roll at its left end.
C
Loosen the left roll core holder locking screw and
remove the roll core holder.
D
Lower the roll onto the roll support.
E
To prevent the media from sliding off the roll,
support the roll at its right end.
60