Configuring Other Tunnel Properties For A Gmpls Uni Tunnel - Cisco ASR 9000 Series Configuration Manual

Configuring TE for GMPLS UNI
Command or Action
Step 6
tunnel-id number
Example:
RP/0/RSP0/CPU0:router(config-te-gmpls-tun)#
tunnel-id 100
Step 7 destination ipv4 unicast address
Example:
RP/0/RSP0/CPU0:router(config-te-gmpls-tun)#
destination ipv4 unicast 10.10.3.4
Step 8 path-option 10 no-ero lockdown
Example:
RP/0/RSP0/CPU0:router(config-te-gmpls-tun)#
path-option 10 no-ero lockdown
Step 9
Use the commit or end command.

Configuring Other Tunnel Properties for a GMPLS UNI Tunnel

Perform this task to configure the optional tunnel properties for a GMPLS UNI tunnel. This configuration is
optional, and if omitted, the GMPLS tunnel is established with the default property values.
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
284
Purpose
Specifies a tunnel-id for a headend router of a GMPLS tunnel.
The tunnel-id is a 16-bit number ranging from 0 to 65535.
Specifies a tunnel destination for a headend router of a GMPLS
tunnel. The destination argument is an IPv4 address.
Specifies the path-option for a headend router of a GMPLS
tunnel.
Note An XRO attribute-set can be specified as part of the
path-option, if required.
commit—Saves the configuration changes and remains within
the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Implementing GMPLS UNI
OL-28381-02