Configuring Rsvp Optical Refresh Interval And Missed Count - Cisco ASR 9000 Series Configuration Manual

Configuring RSVP Optical Refresh Interval and Missed Count

Command or Action
Step 8
neighbor interface-id unnumbered interface-id
Example:
RP/0/RSP0/CPU0:router(config-lmp-gmpls-uni-cntl)#
neighbor interface-id unnumbered 17
Step 9 Use the commit or end command.
Configuring RSVP Optical Refresh Interval and Missed Count
Perform this task to configure optical refresh interval under the RSVP controller submode and to configure
the number of missed refresh messages allowed before optical tunnel states are deleted.
SUMMARY STEPS
1. configure
2. rsvp
3. controller dwdm interface
4. signalling refresh out-of-band interval interval
5. signalling refresh out-of-band missed miss-count
6. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
294
Purpose
Specifies the neighbor's optical interface ID of an LMP
link for a GMPLS UNI controller.
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
Purpose
Enters global configuration mode.
Implementing GMPLS UNI
OL-28381-02