Cisco ASR 9000 Series Configuration Manual page 226

Configuring the Automatic Bandwidth
SUMMARY STEPS
1. configure
2. interface tunnel-te tunnel-id
3. auto-bw
4. application minutes
5. bw-limit {min bandwidth } {max bandwidth}
6. adjustment-threshold percentage [min minimum-bandwidth]
7. overflow threshold percentage [min bandwidth] limit limit
8. Use the commit or end command.
9. show mpls traffic-eng tunnels [auto-bw]
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 interface tunnel-te tunnel-id
Example:
RP/0/RSP0/CPU0:router(config)# interface
tunnel-te 6
RP/0/RSP0/CPU0:router(config-if)#
Step 3
auto-bw
Example:
RP/0/RSP0/CPU0:router(config-if)# auto-bw
RP/0/RSP0/CPU0:router(config-if-tunte-autobw)#
Step 4 application minutes
Example:
RP/0/RSP0/CPU0:router(config-if-tunte-autobw)#
application 1000
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
210
Purpose
Enters global configuration mode.
Configures an MPLS-TE tunnel interface and enables traffic
engineering on a particular interface on the originating node.
Configures automatic bandwidth on a tunnel interface and enters
MPLS-TE automatic bandwidth interface configuration mode.
Configures the application frequency in minutes for the applicable
tunnel.
minutes
Frequency in minutes for the automatic bandwidth
application. Range is from 5 to 10080 (7 days). The default
value is 1440 (24 hours).
Implementing MPLS Traffic Engineering
OL-28381-02