Cisco ASR 9000 Series Configuration Manual page 345

Implementing MPLS Transport Profile
When configuring the LSPs at the midpoint routers, make sure that the configuration does not reflect
Note
traffic back to the originating node.
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. tp mid name
4. tunnel-name name
5. fast-protect
6. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2
mpls traffic-eng
Example:
RP/0/RSP0/CPU0:router(config)# mpls
traffic-eng
Step 3
tp mid name
Example:
RP/0/RSP0/CPU0:router(config-mpls-te)# tp mid
midpt1
Step 4 tunnel-name name
Example:
RP/0/RSP0/CPU0:router(config-mpls-te-tp-mid)#
tunnel-name midtunnel
Step 5
fast-protect
Example:
RP/0/RSP0/CPU0:router(config-mpls-te-tp-mid)#
fast-protect
Step 6 Use the commit or end command.
OL-28381-02
Purpose
Enters global configuration mode.
Enters MPLS TE configuration mode.
Specifies the MPLS-TP tunnel mid-point identifier.
(Optional) Specifies the name of the tunnel whose mid point
is being configured.
Enables MPLS-TP LSP wrapping.
commit—Saves the configuration changes and remains within
the configuration session.
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Configuring MPLS-TP LSP Wrapping
329