Configuring A Lifetime For Rsvp Neighbor Authentication - Cisco ASR 9000 Series Configuration Manual

Configuring RSVP Neighbor Authentication
Command or Action
Related Topics
Key-source Key-chain, on page 72
Security Association, on page 71
RSVP Neighbor Authentication: Example, on page 103

Configuring a Lifetime for RSVP Neighbor Authentication

Perform this task to configure a lifetime for security association for RSVP neighbor authentication mode.
SUMMARY STEPS
1. configure
2. rsvp neighbor IP-address authentication
3. life-time seconds
4. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 rsvp neighbor IP-address authentication
Example:
RP/0/RSP0/CPU0:router(config)# rsvp neighbor
1.1.1.1 authentication
RP/0/RSP0/CPU0:router(config-rsvp-nbor-auth)#
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
94
Purpose
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Enters RSVP neighbor authentication configuration mode. Use the
rsvp neighbor command to specify a neighbor under RSVP.
IP address
IP address of the neighbor. A single IP address for a specific
neighbor; usually one of the neighbor's physical or logical
(loopback) interfaces.
authentication
Configures the RSVP authentication parameters.
Implementing RSVP for MPLS-TE
OL-28381-02