Configuring An Lmp Controller - Cisco ASR 9000 Series Configuration Manual

Configuring LMP for GMPLS UNI
Command or Action
Step 6
router-id ipv4 unicast address
Example:
RP/0/RSP0/CPU0:router(config-lmp-gmpls-uni-nbr-nbr1)#
router-id ipv4 unicast 10.10.4.4
Step 7 Use the commit or end command.

Configuring an LMP Controller

Perform this task to configure an LMP link for a GMPLS UNI controller.
SUMMARY STEPS
1. configure
2. lmp
3. gmpls optical-uni
4. controller dwdm controller
5. neighbor name
6. link-id ipv4 unicast address
7. neighbor link-id ipv4 unicast address
8. neighbor interface-id unnumbered interface-id
9. Use the commit or end command.
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
292
Purpose
Configures the LMP unicast router ID for GMPLS.
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
Implementing GMPLS UNI
OL-28381-02