Cisco ASR 9000 Series Configuration Manual page 91

Implementing RSVP for MPLS-TE
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 rsvp
Example:
RP/0/RSP0/CPU0:router(config)# rsvp
Step 3 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-rsvp)#
interface pos 0/2/0/0
Step 4 bandwidth total-bandwidth max-flow sub-pool
sub-pool-bw
Example:
RP/0/RSP0/CPU0:router(config-rsvp-if)#
bandwidth 1000 100 sub-pool 150
Step 5 Use the commit or end command.
Related Topics
Differentiated Services Traffic Engineering, on page 121
Bandwidth Configuration (MAM): Example, on page 97
Bandwidth Configuration (RDM): Example, on page 98
OL-28381-02
Purpose
Enters global configuration mode.
Enters RSVP configuration mode.
Enters interface configuration mode for the RSVP protocol.
Sets the reservable bandwidth, the maximum RSVP bandwidth
available for a flow and the sub-pool bandwidth on this interface.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
• No—Exits the configuration session without committing the
• Cancel—Remains in the configuration mode, without
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Confirming DiffServ-TE Bandwidth
session.
configuration changes.
committing the configuration changes.
75