Configuring Point-to-Multipoint TE
Command or Action
Step 8
enable
Example:
RP/0/RSP0/CPU0:router(config-mcast-default-ipv6-if)#
enable
Step 9
Use the commit or end command.
Step 10
show pim ipv6 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router# show pim ipv6 interface
tunnel-mte 1
Related Topics
Configuring the Static Group for the Point-to-Multipoint Interface, on page 230
Configuring the Static Group for the Point-to-Multipoint Interface
Perform this task to configure the static group on the Point-to-Multipoint (P2MP) interface to forward specified
multicast traffic over P2MP LSP.
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
230
Implementing MPLS Traffic Engineering
Purpose
Enables multicast routing on the GigabitEthernet
interface.
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
Displays the output for the P2MP-TE tunnel interface
that has IPv6 multicast enabled.
OL-28381-02