Implementing GMPLS UNI
Command or Action
Step 3
gmpls optical-uni
Example:
RP/0/RSP0/CPU0:router(config-mpls-te)#
gmpls optical-uni
RP/0/RSP0/CPU0:router(config-te-gmpls)#
Step 4
Use the commit or end command.
Configuring GMPLS UNI Controller
Perform this task to setup a GMPLS tail in MPLS-TE configuration. This task enables GMPLS UNI controller
submode to configure controllers for establishing GMPLS UNI tunnels. This is the minimal configuration
required at the tunnel tail.
Removal of the GMPLS UNI controller submode results in the immediate destruction of any GMPLS
Note
tunnel established over the controller referenced.
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. gmpls optical-uni
4. controller dwdm interface
5. Use the commit or end command.
OL-28381-02
Purpose
Enters GMPLS UNI configuration submode.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
• No—Exits the configuration session without committing the
• Cancel—Remains in the configuration mode, without
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
session.
configuration changes.
committing the configuration changes.
Configuring TE for GMPLS UNI
281