Configuring Other Tunnel Properties For A Gmpls Uni Tunnel - Cisco CRS Configuration Manual

Implementing GMPLS UNI
Command or Action

Configuring Other Tunnel Properties for a GMPLS UNI Tunnel

Perform this task to configure the optional tunnel properties for a GMPLS UNI tunnel. This configuration is
optional, and if omitted, the GMPLS tunnel is established with the default property values.
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. gmpls optical-uni
4. controller dwdm interface
5. tunnel-properties
6. priority setup-priority hold-priority
7. record-route
8. signalled-name name
9. logging events lsp-status state
10. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)# mpls
traffic-eng
Purpose
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Enters MPLS-TE configuration mode.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Configuring TE for GMPLS UNI
379