Configuring Is-Is To Flood Mpls-Te Link Information - Cisco ASR 9000 Series Configuration Manual

Configuring IS-IS to Flood MPLS-TE Link Information

Related Topics
Flexible Name-based Tunnel Constraints, on page 126
Configure Flexible Name-based Tunnel Constraints: Example, on page 255
Configuring IS-IS to Flood MPLS-TE Link Information
Perform this task to configure a router running the Intermediate System-to-Intermediate System (IS-IS)
protocol to flood MPLS-TE link information into multiple IS-IS levels.
This procedure shows how to enable MPLS-TE in both IS-IS Level 1 and Level 2.
SUMMARY STEPS
1. configure
2. router isis instance-id
3. net network-entity-title
4. address-family {ipv4 | ipv6} {unicast}
5. metric-style wide
6. mpls traffic-eng level
7. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 router isis instance-id
Example:
RP/0/RSP0/CPU0:router(config)# router isis
1
Step 3 net network-entity-title
Example:
RP/0/RSP0/CPU0:router(config-isis)# net
47.0001.0000.0000.0002.00
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
188
Implementing MPLS Traffic Engineering
Purpose
Enters global configuration mode.
Enters an IS-IS instance.
Enters an IS-IS network entity title (NET) for the routing
process.
OL-28381-02