Configuring The Automatic Bandwidth - Cisco ASR 9000 Series Configuration Manual

Implementing MPLS Traffic Engineering

Configuring the Automatic Bandwidth

Perform these tasks to configure the automatic bandwidth:
Configuring the Collection Frequency
Perform this task to configure the collection frequency. You can configure only one global collection frequency.
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. auto-bw collect frequency minutes
4. Use the commit or end command.
5. show mpls traffic-eng tunnels [auto-bw]
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2
mpls traffic-eng
Example:
RP/0/RSP0/CPU0:router(config)# mpls
traffic-eng
RP/0/RSP0/CPU0:router(config-mpls-te)#
Step 3 auto-bw collect frequency minutes
Example:
RP/0/RSP0/CPU0:router(config-mpls-te)#
auto-bw collect frequency 1
Step 4 Use the commit or end command.
OL-28381-02
Purpose
Enters global configuration mode.
Enters MPLS-TE configuration mode.
Configures the automatic bandwidth collection frequency, and controls
the manner in which the bandwidth for a tunnel collects output rate
information; but does not adjust the tunnel bandwidth.
minutes
Configures the interval between automatic bandwidth adjustments
in minutes. Range is from 1 to 10080.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Configuring the Automatic Bandwidth
207