Cisco ASR 9000 Series Configuration Manual page 240

Configuring the Shared Risk Link Groups
Command or Action
Step 13
index 1 exclude-address 192.168.92.1
Example:
RP/0/RSP0/CPU0:router:router(config-if)# index
1 exclude-address 192.168.92.1
Step 14 index 2 exclude-srlg 192.168.92.2
Example:
RP/0/RSP0/CPU0:router(config-if)# index 2
exclude-srlg 192.168.192.2
Step 15 Use the commit or end command.
Step 16 show mpls traffic-eng tunnels topology path
destination ip-address explicit-path-name name
Example:
RP/0/RSP0/CPU0:router# show mpls traffic-eng
tunnels topology path destination 192.168.92.125
explicit-path-name backup-srlg-nodep
Related Topics
MPLS Traffic Engineering Shared Risk Link Groups, on page 145
Explicit Path, on page 145
Fast ReRoute with SRLG Constraints, on page 146
Importance of Protection, on page 148
Delivery of Packets During a Failure, on page 149
Multiple Backup Tunnels Protecting the Same Interface , on page 149
Weighted-SRLG Auto-backup Path Computation, on page 149
SRLG Limitations, on page 150
Configure the MPLS-TE Shared Risk Link Groups: Example, on page 259
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
224
Implementing MPLS Traffic Engineering
Purpose
Specifies the protected node IP address to be excluded from
the explicit path.
Specifies the protected link IP address to get SRLGs to be
excluded from the explicit path.
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Displays the path to the destination with the constraint
specified in the explicit path.
OL-28381-02