Configuring An Ospf Area Of Mpls-Te - Cisco ASR 9000 Series Configuration Manual

Implementing MPLS Traffic Engineering
Command or Action
Step 4
address-family {ipv4 | ipv6} {unicast}
Example:
RP/0/RSP0/CPU0:router(config-isis)#
address-family ipv4 unicast
Step 5 metric-style wide
Example:
RP/0/RSP0/CPU0:router(config-isis-af)#
metric-style wide
Step 6 mpls traffic-eng level
Example:
RP/0/RSP0/CPU0:router(config-isis-af)# mpls
traffic-eng level-1-2
Step 7 Use the commit or end command.

Configuring an OSPF Area of MPLS-TE

Perform this task to configure an OSPF area for MPLS-TE in both the OSPF backbone area 0 and area 1.
OL-28381-02
Purpose
Enters address family configuration mode for configuring IS-IS
routing that uses IPv4 and IPv6 address prefixes.
Enters the new-style type, length, and value (TLV) objects.
Enters the required MPLS-TE level or levels.
commit—Saves the configuration changes and remains within
the configuration session.
end—Prompts user to take one of these actions:
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Configuring an OSPF Area of MPLS-TE
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
189