Configuring Default Admin Weight - Cisco ASR 9000 Series Configuration Manual

Implementing MPLS Traffic Engineering

Configuring Default Admin Weight

Perform this task to configure a default admin weight to apply to all SRLG values if a specific admin weight
is not configured under the SRLG value configuration mode.
SUMMARY STEPS
1. configure
2. mpls traffic-eng srlg
3. admin-weight weight
4. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2
mpls traffic-eng srlg
Example:
RP/0/RSP0/CPU0:router(config)# mpls
traffic-eng srlg
Step 3 admin-weight weight
Example:
RP/0/RSP0/CPU0:router(config-mpls-te-srlg)#
admin-weight 10
Step 4 Use the commit or end command.
OL-28381-02
Purpose
Enters global configuration mode.
Enters MPLS TE SRLG configuration mode.
Configures default admin-weight for all the SRLG values. Range
is from 0-4294967295. Default is 1. The example shows how to
configure an admin-weight of 10 for all the SRLG values.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
• No—Exits the configuration session without committing the
• Cancel—Remains in the configuration mode, without
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Configuring the Shared Risk Link Groups
session.
configuration changes.
committing the configuration changes.
225