Configuring The Delay The Tunnel Takes Before Reoptimization - Cisco ASR 9000 Series Configuration Manual

Implementing MPLS Traffic Engineering
DETAILED STEPS
Command or Action
Step 1
mpls traffic-eng path-protection switchover
tunnel-te tunnel-ID
Example:
RP/0/RSP0/CPU0:router# mpls traffic-eng
path-protection switchover tunnel-te
6
Step 2 Use the commit or end command.
Related Topics
Path Protection, on page 135
Pre-requisites for Path Protection, on page 135
Restrictions for Path Protection, on page 136
Restrictions for Explicit Path Protection, on page 137
Configure Tunnels for Path Protection: Example, on page 258

Configuring the Delay the Tunnel Takes Before Reoptimization

Perform this task to configure the time between when a path-protection switchover event is effected on a
tunnel head to when a reoptimization is performed on that tunnel. This timer affects only the required
reoptimization that is attempted due to a switchover and does not override the global reoptimization timer.
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. reoptimize timers delay path-protection seconds
4. Use the commit or end command.
OL-28381-02
Purpose
Forces the path protection switchover of the Point-to-Point (P2P) tunnel
on the tunnel-te interface.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without committing
the configuration changes.
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Configuring Path Protection on MPLS-TE
205