Configuring Session Protection - Cisco ASR 9000 Series Configuration Manual

Configuring Session Protection

Command or Action
Related Topics
Local Label Allocation Control, on page 15
Configuring Local Label Allocation Control: Example, on page 55
Configuring Session Protection
Perform this task to configure LDP session protection.
By default, there is no protection is done for link sessions by means of targeted hellos.
SUMMARY STEPS
1. configure
2. mpls ldp
3. session protection [ for peer-acl ] [ duration seconds ]
4. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 mpls ldp
Example:
RP/0/RSP0/CPU0:router(config)# mpls ldp
Step 3 session protection [ for peer-acl ] [ duration
seconds ]
Example:
RP/0/RSP0/CPU0:router(config-ldp)#
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
38
Implementing MPLS Label Distribution Protocol
Purpose
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Enters the MPLS LDP configuration mode.
Configures LDP session protection for peers specified by peer-acl
with a maximum duration, in seconds.
OL-28381-02