Cisco ASR 9000 Series Configuration Manual page 62

Disabling LDP Auto-Configuration
SUMMARY STEPS
1. configure
2. mpls ldp
3. interface type interface-path-id
4. igp auto-config disable
5. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 mpls ldp
Example:
RP/0/RSP0/CPU0:router(config)# mpls ldp
RP/0/RSP0/CPU0:router(config-ldp)#
Step 3 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-ldp)#
interface pos 0/6/0/0
Step 4
igp auto-config disable
Example:
RP/0/RSP0/CPU0:router(config-ldp-if)# igp
auto-config disable
Step 5
Use the commit or end command.
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
46
Implementing MPLS Label Distribution Protocol
Purpose
Enters global configuration mode.
Enters the MPLS LDP configuration mode.
Enters interface configuration mode and configures an interface.
Disables auto-configuration on the specified interface.
commit—Saves the configuration changes and remains within
the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
OL-28381-02