Configuring Point-To-Multipoint Te; Enabling Multicast Routing On The Router - Cisco ASR 9000 Series Configuration Manual

Configuring Point-to-Multipoint TE

Command or Action
Step 5
Use the commit or end command.
Configuring Point-to-Multipoint TE
You must enable multicast routing on the edge router before performing Point-to-Multipoint (P2MP) TE
configurations. To configure Point-to-Multipoint TE, perform these procedures:

Enabling Multicast Routing on the Router

Perform this task to enable multicast routing on the router to configure P2MP tunnels.
Before You Begin
• To configure Point-to-Multipoint (P2MP) tunnels, you must enable multicast routing on the router.
• The customer-facing interface must enable multicast.
SUMMARY STEPS
1. configure
2. multicast-routing
3. address-family {ipv4 | ipv6 }
4. interface tunnel-mte tunnel-id
5. enable
6. exit
7. interface type interface-path-id
8. enable
9. Use the commit or end command.
10. show pim ipv6 interface type interface-path-id
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
228
Purpose
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Implementing MPLS Traffic Engineering
OL-28381-02