Configuring The Static Group For The Point-To-Multipoint Interface - Cisco CRS Configuration Manual

Implementing MPLS Traffic Engineering
Command or Action
Step 10
show pim ipv6 interface type interface-path-id
Example:
RP/0/RP0/CPU0:router# show pim ipv6 interface
tunnel-mte 1
Related Topics
Point-to-Multipoint Traffic-Engineering Overview, on page 193
Configure Point-to-Multipoint for the Source: Example, on page 363
Configure the Point-to-Multipoint Solution: Example, on page 364
Configuring the Static Group for the Point-to-Multipoint Interface, on page 309

Configuring the Static Group for the Point-to-Multipoint Interface

Perform this task to configure the static group on the Point-to-Multipoint (P2MP) interface to forward specified
multicast traffic over P2MP LSP.
SUMMARY STEPS
1. configure
2. router mld
3. vrf vrf-name
4. interface tunnel-mte tunnel-id
5. static-group group-address
6. Use the commit or end command.
7. show mrib ipv6 route source-address
Purpose
• Yes— Saves configuration changes and exits the
• No—Exits the configuration session without
• Cancel—Remains in the configuration session,
Displays the output for the P2MP-TE tunnel interface
that has IPv6 multicast enabled.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Configuring Point-to-Multipoint TE
configuration session.
committing the configuration changes.
without committing the configuration changes.
309