Table of Contents
Advertisement
Configuring the Printer
3.4.1 SELECT CURRENT MACRO
The printer stores up to three user settings in MACRO 1 up to MACRO 3.
Use the [STOP # ] key to activate this function. The active macro is displayed first. Press
the [COMPRESS
the [STOP # ] key. The printer will save the selected macro immediately. After the
procedure the printer changes into the ON-LINE mode and will now work with the new
settings.
3.4.2 SELECT USER TO SETUP
With the module SELECT USER TO SET UP you have the choice between MACRO 1,
MACRO 2, and MACRO 3. Select the macro witch should be changed.
Note:
If you have selected all new items and have these confirmed with the [STOP ] key,
don t forget to activate the module SAVE PARAMETERS.
3.4.3 CONFIGURE
The following items can be modified according to the PR 9 parameters.
Note:
In the different emulations the items shown are not equal. The option's which are
printed in bold indicate the actual setting.
Parameter
RESUME DEFAULT VALUE
INTERFACE
RS1 EMULATION
3-6
] key until you find the macro for your application and selected it with
CONFIGURE
Option
NO
YES
DUAL
INTERFACE
SERIAL1
CX
OLIVETTI
OKI
IBM
LQ1600K
IBM 9068
Explanation
Select resume default
value or not,
If select YES, jump to
SAVE PARAMETERS the
parameters will be resumed
the default value if pressing
[STOP
] to confirm.
Select the interface you
want to use.
Select your RS1 emulation
Note
This option is mainly
used to resume the
default value when the
menu parameters
have been changed in
disorder.
DUAL or CX will be
selected only if an
optional interface card
is installed.
Advertisement
Table of Contents
