Epson PR9 User Manual page 35

Parameter
MODIFY RS1 CONFIG
BAUD RATE (RS1)
BITS/CHARACTER (RS1)
PARITY (RS1)
STOP BITS (RS1)
DSR (RS1)
CX EMULATION
CX STROBE EDGE
DRAFT SPEED
LQ TYPE
NEEDLES SWITCH
CONFIGURE
Option Explanation
NO If YES configure also Baud
YES Rate, bits/character, parity
and stop bit.
NO not used with
CX EMULATION .
2400 Controls the speed of the
4800 data transfer.
9600 The baud rate for the
19200 printer should be
corresponding to the
settings of the computer.
87 Number of bits that
represent a character.
NONE The data transfer will be
EVEN checked by an even or odd
ODD parity bit.
12 Number of stop bits which
are in use.
NO SERIAL 1 handle the DSR
YES signal or not.
IBM The emulation determines
LQ 1600K the set of commands
IBM 9068 available for the printer:
OLIVETTI
OKI
RISING EDGE Select the trig mode of the
FALLING EDGE printer strobe signal (CX
present.
NORMAL Select printer speed in draft
HIGH SPEED mode.
NLQ1 Select the printer type in
NLQ2 LQ mode.
LQ2
YES YES = activated
NO No = ignored
Configuring the Printer
Note
Only displayed if
MODIFY RS1
CONFIG
is set to YES
Only displayed if
MODIFY RS1
CONFIG
is set to YES
Only displayed if
MODIFY RS1
CONFIG
is set to YES
Only displayed if
MODIFY RS1
CONFIG
is set to YES
Only displayed if
MODIFY RS1
CONFIG
is set to YES
3-7