3.4.9 IBM 9068 CONFIGURE
The following items can be modified according to the IBM 9006 parameters.
Note:
In the different emulations the items shown are not equal. The option's which are
printed in bold indicate the actual setting.
Parameter
PRINTER ID
SERIAL PROTOCOL
HIGH SPEED PRINTING
LEFT MARG. (1/60")
TOP MARG. (1/60")
BOF ADJUST (0.5 mm)
FEED ADJUST (1/10")
LPI
UNIDIRECTION PRINT
LF+CR
CR+LF
IBM 9068 CONFIGURE
Option
Explanation
1D
Selecting the printer ID:
1E
1D = 4748
1E = 9055-001
Selecting the serial
EFFECTIVE CTS/FDD
NO CTS/FDD
communication interface
with the host system.
EFFECTIVE CTS/FDD =
CTS/FDD active.
NO CTS/FDD = CTS
without FDD.
NO
Selecting high speed
YES
printing mode.
NO = no draft mode.
YES: = the print mode
always is draft.
0
To adjust the left margin
-6 up to +6
more to left or right in units
of 1/60" inch (about 4 mm).
0
To adjust the top margin in
-6 up to +6
units of 1/60" inch (about
4 mm).
0
Adjust the bottom margin in
-10 up to +10
units of 0.5 mm
0
Adjustment when the form
-10 up to +5
feed 10 inch, 0.5 inch
5
Defines the number of lines
6
printed per inch.
8
EFFICIENCY
Select the printing direction
IGNORE
for graphics or ignore.
NO
YES: LF = LF + CR
YES
NO: LF = LF
NO
YES: CR = LF + CR
YES
NO: CR = CR
Configuring the Printer
Note
FDD = Finance Device
Driver
TOF = Top Of Form
BOF = Bottom Of Form
This item will be valid
2.09.
with the release
3-23