Table of Contents
Advertisement
Appendix D EPSON LQ-Emulation Commands
FS SO
This command causes to print characters following this command on the same line as
horizontally enlarged (double width) in Chinese mode.
Hex:
(1C 0E)H
Decimal:
(28 14)D
Octal:
(34 16)O
FS T n1 n2
Set the character pitch of half width Chinese character to be (n1 * 256 + n2)/180 inch.
Hex:
(1C 54 n1 n2)H
Decimal:
(28 84 n1 n2)D
Octal:
(34 124 n1 n2)O
The range of n2: 12 up to 255
FS U
Set adjustment mode of half width Chinese character, that means the width of half width
character is just the half of the double byte character's width.
This mode is the power on mode.
Note:
Hex:
(1C 55)H
Decimal:
(28 85)D
Octal:
(34 125)O
FS V
Reset adjustment mode of half width Chinese character, that means the pitch of the half-
width character is set to 12 CPI.
Hex:
(1C 56)H
Decimal:
(28 86)D
Octal:
(34 126)O
D-36
Set Double Width Printing in Chinese character (one line)
Set pitch of half width Chinese character
Set Adjustment of half width Chinese character
Reset Adjustment of half width Chinese character
Advertisement
Table of Contents
