Table of Contents
Advertisement
FS DC4
Reset double width printing for Chinese character (one line)
Hex:
(1C 14)H
Decimal:
(28 20)D
Octal:
(34 24)O
FS J
In Chinese mode this command set rotation printing, it is valid until command FS K is
received
Hex:
(1C 4A)H
Decimal:
(28 74)D
Octal:
(34 112)O
FS K
Reset Chinese rotation printing in Chinese mode
Hex:
(1C 4B)H
Decimal:
(28 75)D
Octal:
(34 113)O
FS S n1 n2
Set the character pitch of Chinese character to be (n1 * 256 + n2)/180 inch.
Hex:
(1C 53 n1 n2)H
Decimal:
(28 83 n1 n2)D
Octal:
(34 123 n1 n2)O
The range of n2: 12 up to 255
FS SI
This command causes to print Chinese character in compressed mode, the width of
Chinese character will be half of the original.
Hex:
(1C 0F)H
Decimal:
(28 15)D
Octal:
(34 17)O
Reset Double Width Printing for Chinese Character (on one)
Set Compressed Printing for Chinese Character
Appendix D EPSON LQ-Emulation Commands
Set Rotation printing
Reset Rotation printing
Set pitch of Chinese character
D-35
Advertisement
Table of Contents
