Chinese Mode - Epson PR9 User Manual

D.2.12 Chinese Mode
S FS $ n :
S FS 2 n1 n2
S FS B n
S FS J
S FS K
S FS N
S FS O
S FS P
S FS Q
S FS R
S FS S
S FS _
S FS p
S FS q
S FS r
S FS s
S FS t
S FS u
FS $ n
This command code sets Chinese character's spacing.
Hex (1C 24 n)H
Decimal (28 36 n)D
Octal (34 44 n)O
This code specifies Half Corner character's spacing to n/180 inch and when n is less
than 128 this code specifies Full Corner character's spacing to n/90 inch, when n is
greater than 127 this code specifies Full Corner character's spacing to 255/180 inch.
FS 2 n1 n2
This command code downloads user defined character's bit map to RAM. Each
character's bit map must be defined as a 72 byte sequence. Every time use this code can
only load one character's bit map to RAM.
Hex (1C 32 n1 n2)H
Decimal (28 50 n1 n2)D
Octal (34 62 n1 n2)O
(n1 & 0x80) = 0x78 , 0x79 , 0x7a
Note:
n2 > 0x20 and n2 < 0x7f
Set Chinese Character's Spacing
User Defined Character Download
Set / Reset OCR Character Print mode
Set Character Left Rotate 90 degree Print
Reset Character Left Rotate 90 degree Print
Set Superscript Mode
Reset Superscript Mode
Set Subscript Mode
Reset Subscript Mode
Set Superscript/ Subscript Mode
Reset Superscript / Subscript Mode
Set Half Corner Character Compose Print
Set Chinese Character Double Width Mode
Reset Chinese Character Double Width Mode
Set CHINA Half Corner Character Mode
Reset CHINA Half Corner Character Mode
Set Half Corner Character Rotation Forbidden
Set Half Corner Character Rotation Allowed
Appendix B OKI-Emulation Commands
Set Chinese Character's Spacing
User Defined Character Download
B-31