Epson PR9 User Manual page 196

ESC 3 n
Line Feed - n/216"
n = 1 - 255
Sets the n/216" (0,1176 x n mm) line feed.
This is the line feed recommended for graphic printing (BIM). If programmed to 24/216", it
ensures that the various lines in 8-needle graphic printing meet perfectly.
It remains valid until a new line feed command is received.
To obtain precise line feeds, always use multiples of 3 for parameter n.
Note:
ESC A n
Line Feed - n/72" or n/60"
n = 1 - 85
If the parameter AGM : NO has been selected in the SETUP ,it sets the n/72" (0,3528 x n
mm) line feed; If the parameter AGM : YES has been selected in the SETUP ,it sets the
n/60" (0,432 x n mm) line feed.
It will only be executed when the command ESC 2 is received. Until then, the current line
feed remains valid.
n = 0 does not change the current line feed.
Note:
ESC A n
Line Feed - n/72"
n = 1 - 85
Sets the n/72" (0,3528 x n mm) line feed.
It will only be executed when the command ESC 2 is received. Until then, the current line
feed remains valid.
n = 0 does not change the current line feed.
Note:
Appendix C IBM ProPrinter X24 and IBM ProPrinter II Commands
(IBM ProPrinter II)
Hexadecimal code: 1B 33 n
(IBM ProPrinter X24)
Hexadecimal code: 1B 41 n
(IBM ProPrinter II)
Hexadecimal code: 1B 41 n
C-9