Table of Contents
Advertisement
Appendix D EPSON LQ-Emulation Commands
D.2.7
Tabulation
S ESC B ... :
Set vertical tab stops of tab set
S ESC D ... :
Set horizontal tab stops
S ESC b ... :
Set vertical tab stops in tab set
S ESC / n :
Select the current vertical tab set
S HT :
Horizontal tabulation
S VT :
Vertical tabulation
ESC B n1 ... nk NUL
Set vertical tab stops at the lines specified by n1 to nk (in the current line spacing) in tab
set 0, as measured from the top-of-form position. Tab stop must be in ascending order,
code NUL (0x00) will end this command.
A maximum of 16 vertical tab stops can be set for each tab set.
Hex:
(1B 42)H
Decimal:
(27 66)D
Octal:
(33 102)O
ESC D n1 ... nk NUL
Set horizontal tab stops (in the current character pitch) at the columns specified by n1
to nk, as measured from the left-margin position. Tab stop must be in ascending order,
code NUL (0x00) will end this command.
A maximum of 30 horizontal tab stops can be set.
Hex:
(1B 44)H
Decimal:
(27 68)D
Octal:
(33 104)O
ESC / n
Select the current vertical tab set.
Hex:
(1B 2f n)H
Decimal:
(27 47 n)D
Octal:
(33 57 n)O
n = 0 up to 7
D-24
Set Tab Stop of Vertical Tab Set 0
Set Horizontal Tab Stop
Select vertical tab set
Advertisement
Table of Contents
