Table of Contents
Advertisement
Expansion cards and backup units
Ê Place the controller on the mounting tabs on the slot bracket (1).
Ê Secure the slot bracket to the controller with two M3 x 4.5 mm screws (2).
9.4.1.3
Installing the SAS RAID controller
Ê Remove the SAS RAID controller from its protective packaging.
I
For further instructions regarding controller settings, please refer to
the accompanying documentation.
Ê If applicable, attach the required slot bracket to the expansion card as
described in section
Figure 90: Installing the SAS RAID controller
Ê Carefully insert the RAID controller into PCI slot 7 and press down firmly until
it is fully seated in the slot (1).
I
For slot preferences, please refer to section
page
173.
Ê Secure the RAID controller with the screw on the RAID card holder (2).
192
"Preparing the SAS RAID controller" on page
Upgrade and Maintenance Manual
191.
"Basic information" on
RX2520 M1
Advertisement
Table of Contents
