Figure 86: Installing the expansion card
Ê Carefully insert the expansion card into the desired PCI slot and press down
firmly until it is fully seated in the slot.
Ê Fasten the expansion card with the screw.
Ê If applicable, install SFP+ transceiver modules into the new expansion card,
as described in section
Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
cables" on page
Ê If applicable, connect a FBU to the expansion card as described in section
"Installing a FBU" on page
9.3.1.4
Concluding steps
"Reassembling" on page 59
Ê
Ê Reconnect all external cables to the expansion card.
"Connecting the server to the power source" on page 64
Ê
"Switching on the server" on page 66
Ê
"Updating RAID controller firmware" on page 79
Ê
RX2520 M1
"Installing SFP+ transceiver modules" on page
393.
198.
Upgrade and Maintenance Manual
Expansion cards and backup units
212.
"List of used
185